Put the strap around the object to be tensioned and make sure there is no stroke in the strap.
Pass the strap through the front of the clamp buckle and tighten the strap. When doing this, make sure that the tape does not pass sharp edges due to damage to the tape. If it does, use a protective corner or protective cover if necessary. Raise the flap of the clamp buckle to allow the strap to pass smoothly through this. Release the flap of the clamp buckle again so that the strap clamps and pull as tightly as possible.
Roll up the excess piece of tape and put an elastic band around it or make sure it is safely tucked away. Loose flapping tape is dangerous during transport.
